Views: 9 Author: Site Editor Publish Time: 2022-09-13 Origin: Site
The twist cabling machine can be used for bunching and stranding small cross-section cable wires and is composed of a single twist cabling machine, a transmission line plate, a stirring cage, and an electric motor.
1 unique tool, measuring instruments into the work on the table, and check the measuring instruments are not to zero
2. Check whether the precision twist cabling machine is standard, especially the switch-off equipment and protective cover power off protection power switch. If there are abnormalities, immediately report maintenance personnel to complete maintenance
3. according to the production planning, ready semi-finished products processing, and check whether the processing of the semi-finished products is work experience qualified and in line with the process standards, and qualified semi-finished products processing to the single twist cabling machine, set on the cone sleeve, and adjust the support force
4. According to the process standard number, section diameter, stranding direction hanging drive gear, adjust the stranding direction according to the process standard selected and line die on. According to the requirements of the preparation of the collection plate, check the winding plate is intact and the collection plate is installed in the collection frame
5. Pull a traction line through the wire wheel, pipe mouth has been pulled to the traction wheel in the cage, and around the traction wheel 3 ~ 4 turns, one end of the traction line fixed immobile in the collection plate
1. the single line of railroad each over the disconnected automatic parking equipment, through the sub-tow line, pulled to the front of the parallel die, and the electronic wire bundle screwed into a share, across the parallel die, drag out 0.5 ~ 1.0 meters, and the parallel die fixed immobile in the mold seat
2. Connect the wire strands and traction line, close the protective cover, delay the start of the machine, and so on. The wire knot is pulled to the winding disk, and wind disk 2 turns. Turn off the machine, cut off the unqualified part of the knot, pull out the traction wire, and fix the qualified knot in the coil
3. Start the machine bundle stranded 20 ~ 30 meters. According to the requirements of the single-line railroad, cable diameter has not been pulled thin, stranding is not in line with the process standards, the core is not shiny, and there is no loose, to determine the accuracy of the production of manufacturing again
4. In the case of precision twist cabling machine on, to often observe and check the single twist cabling machine winding disk running condition and the receipt of the lined tray line row condition, such as abnormalities, should be an emergency stop, find the situation and deal with the machine again after the start
5. After the end of production and manufacturing, fill out the product manufacturing card, placed in the inspection area, such as process inspectors determine qualified and stamped, placed in the qualified products area to be pre-inspected
Various kinds of bundle stranding can not be a whole bunch of welding. Single-line railroads allow welding, but the same cross-section does not allow more than two connectors. The spacing between the two connectors should not be less than 300mm. The interface should be solid and clean. The bundle of the core can not be missing, disconnected, loose, or pressure stacking condition in the core of the single-line railroad error. Section diameter and stranding should be in line with the process standards.
Purchase high-quality twist cabling machine equipment. Welcome to contact the professional twist cabling machine manufacturer - Zhaohong. We are focused on providing wire harness equipment manufacturers with wire production solutions. If you need to establish a wire production line, Zhaohong is your best choice.
